EN - RU
Cuttings Re-injection (CRI)

Cuttings Re-injection (CRI)

Cuttings Re-injection

Product Introduction

During drilling process, various wastes like waste oil-water mixture, oil-based mud and oil-bearing cuttings are generated. In order to avoid environmental pollution, these hazardous wastes are treated through slurry making method, and then pumped into proper formation. The method of drilling waste treatment is called drilling cuttings re-injection (CRI).




Receive Skid

Mainly used for receive and store the solid fluid, installed with the agitators and centrifugal pumps, to mix and transfer the solid fluid.



Slurry Skid

Use the centrifugal pump for milling and make slurry, installed with the agitators and shale shaker, to filtrate the slurry.



Holding Tank Skid

Mainly used for store the slurry, installed with the agitators and centrifugal pumps, to mix and transfer slurry.


Re-injection Pump Skid

Use the electric motor to drive the plungerpump, to pump the slurry into the well, and monitor the Pressure and flow ratetimely.



MCC Container

Install all the electric control equipmentinside one container, cooling with air conditioner.




elizabeth-finemade@outlook.com
+86 177 6209 5829
elizabeth@hrada.net